• Volant CRT

    What To Do


    Casing Equipment


    It’s Too Late


    When I was beginning with pillar drills, I discovered every one of the terms for the different parts as well as dimensions actually perplexing. This short article is created to help you if you are aiming to choose a drill and also have to recognize just what all the terms and jargon means.


    Components Found on Column Drills


    Pierce head-- the assembly that composes the chuck, spindle, drill little bit, motor and also pulleys.

    Base-- the hefty "foot" of the maker that is bolted to the floor in the case of a larger column drill or the workbench in the case of a smaller sized bench-mounted drill.

    Column-- this is the upright pillar that provides the column drill one of its names (confusingly, its other typical names are "bench drill" and "pierce press").

    Pin-- the vertical axle that remains in line with the drill little bit as well as attaches the chuck to the drill head.

    Chuck-- the setting up that fits into the pin and holds the drill bit.

    Table-- this is often little bit more than a walk in smaller bench drill designs. It’s the support for the job piece to be drilled, as well as is affixed to the column some range below the head and also over the base. Tables can be rectangular or round, as well as some can be slanted to permit angled exploration via a work piece. Column drill devices can be acquired to clamp or cradle job pieces in various angles.

    Deepness gauge-- a setup that enables the bench drill to pierce an opening part-way through a work piece.


    The Significance of Measurements in Drill Specs


    Throat range-- this is the measurement from the nearest side of the pillar to the pin centre.

    Swing-- this is a common denominator of the ability of column drills and also is specified as twice the throat range, or to place it an additional way, the optimum size of disc in which you can pierce a central opening.

    Spindle taper-- this defines the form of completion of the pin. There are long, brief, female and male types. The chuck should be compatible with the pin taper.

    Collar Size-- this is the external size of the collar or chuck assembly that holds the little bit.

    Chuck size-- this is the diameter of the inner opening of the chuck assembly, so it specifies the maximum size of little bit stem that the drill could take. Due to this it is additionally known merely as the drilling ability.

    Spindle traveling-- this is the amount whereby the pin can be reduced or increased vertically as well as specifies the maximum depth of opening you could pierce in one pass.

    Maximum distance spindle-to-table-- this range defines the deepest work item that you could get onto the table.

    Maximum distance spindle-to-base-- this is similar to the above and specifies the maximum depth of work item you can pierce with the table removed.


    For More Information About Volant CRT, Casing Running Tool, Tesco CRT, CRTI, Tubular Running Tool, Casing Equipment, Drilling Casing Tool, Drill Casing, Casing Tool, Casing Jacks


    Contact Us:


    Address: 10555 FM 1301, Boling-Iago, TX 77420, USA


    Ph: +1 979-657-1216




    G Maps: https://www.google.com/maps/place/DrawWorks+LP/@29.267955,-95.9501196,17z/data=!4m5!3m4!1s0x8641a75dbeb06d9b:0x36b4ecaaeb3be03e!8m2!3d29.2679503!4d-95.9479309

  • Comments

    No comments yet

    Suivre le flux RSS des commentaires

    Add comment

    Name / User name:

    E-mail (optional):

    Website (optional):